Tatra T813 8x8 PROFA in 1:10 scale
-
- VIP Member
- Posty: 285
- Rejestracja: 2006-07-12, 16:23
- Imię:
- Lokalizacja: Czech Republik
- Otrzymał podziękowań: 3 razy
Shortening cardan joints
Thanks all for your comments
Other photo serial, this time shortening cardan joints. First drill a hole 6H7 in the center of cardan. I use a small collet hand made from sheet of tin.
Next, thread M5 for fixing to the shaft:
Preparation tool for fix cardan to the chuck and ballbearing on the other side - to inside of drilling head.
And now we can shorten:
Finally, cut the edge of the cardan:
And in the meantime, finished third axle:
Other photo serial, this time shortening cardan joints. First drill a hole 6H7 in the center of cardan. I use a small collet hand made from sheet of tin.
Next, thread M5 for fixing to the shaft:
Preparation tool for fix cardan to the chuck and ballbearing on the other side - to inside of drilling head.
And now we can shorten:
Finally, cut the edge of the cardan:
And in the meantime, finished third axle:
- robert3384
- Teoretyk
- Posty: 348
- Rejestracja: 2013-12-04, 11:08
- Imię: Robert
- Lokalizacja: EKU
-
- VIP Member
- Posty: 285
- Rejestracja: 2006-07-12, 16:23
- Imię:
- Lokalizacja: Czech Republik
- Otrzymał podziękowań: 3 razy
Steering servo
Steering servo will be Hitec HS805 adjusted by additional gearbox to 96kg/cm power
There is instructions of adjustment in czech language:
http://forum.rctrucktrial.cz/viewtopic.php?f=10&t=1197
There is instructions of adjustment in czech language:
http://forum.rctrucktrial.cz/viewtopic.php?f=10&t=1197